Whirlpool SS209 - Emptying the Bucket

МОТЕ
Emptying the bucket
1. When the bucket із full, tha unit stops and 'Full' > light flashes.
2. Ramove bucket by pulling out and Iifting carefully.
3. Empty water, clean bucket and replace.
4. По not remove the bucket too soon, as the unit may still be dripping.
5. Do nat remove or damage the float in the bucket, as this prevents proper
operation.
6. The 'Full' ag light illurminates if the bucket is incorrectly positioned.
Pulli out
Drainirig
You may use a pipe with inner diameter of
11.5-12mm for continuous draining:
1. Remove the hole covering at the back with a
Screwdriver, pass pipe through hole and connect
to outlet nozzla.
2. Ensure the pipe to the drain has no kinks.
Moving
1. Usa te retractable handle and keep the unit as upright as possible, never on
its side.
2, Unplug unit and empty water bucket before moving.
3. Before switching on check bucket positioning.