www.whisperkool.com | Page 3
SC PRO Series
BEFORE YOU START
This guide is meant to serve as a quick reference for installation of the WhisperKOOL unit. The remainder of this owner’s manual
will provide more detailed information and instructions.
Upon receiving the WhisperKOOL cooling unit:
1. Inspect the unit before installation. If damage is found, please contact your distributor or WhisperKOOL Customer Service
at support@WhisperKOOL.com.
2. The unit should remain in an upright position for 24 hours prior to operation.
3. The WhisperKOOL SC PRO 2000, SC PRO 3000, and SC PRO 4000 units require a dedicated 115-volt, 15-amp circuit.
The WhisperKOOL SC PRO 8000 unit requires a dedicated 115-volt, 20-amp circuit. Use a surge protector with the
WhisperKOOL units. Do not use a GFI (ground fault interrupter) line. GFI’s are too sensitive to be used with WhisperKOOL
units, they will trip prematurely and prevent the unit from operating.
4. For your convenience, the WhisperKOOL unit has two power inlets: one on the side of the unit, and the other on the back.
Use the selector switch, located on the right side of the unit, to select the inlet you would like to use.
5. The unit is designed to gently cool down the temperature of the cellar over time by cycling cooler air throughout.
Test the unit prior to installation.
6. You are required to install a drain line to remove condensation from the unit.
7. The WhisperKOOL unit is intended for use in properly designed and constructed wine cellars. Hire a professional wine
storage consultant with a valid contractor’s license to build your wine cellar.
Never try to open the WhisperKOOL unit, repair it yourself, or use a service company
without WhisperKOOL’s authorization. This will void your warranty.
If you encounter a problem with your WhisperKOOL unit, please refer to the Troubleshooting Guide. If you have any further
questions or concerns, or need assistance, please contact WhisperKOOL Customer Service at support@WhisperKOOL.com.
Please be sure all testing has been completed prior to contacting Customer Service. Please have your results ready for your
representative.
Please review the installation instructions in this manual. Failure to follow proper installation
procedures will void your warranty.
To Next Page
Loading...
Need help?
General
