12
Configuring Your Scanner
Preprogrammed Frequencies
Your scanner includes 153 preprogrammed
frequencies, which you can load into Channels
1 to 153. For a list of these frequencies, see
“Preprogrammed Frequency List” on page 23.
To load the pregprogrammed frequencies:
1. Turn off the scanner and then turn it on again.
2. While WELCOME message appears, press PGM.
3. Load –Fr– appears, then YES––Ent and No––
CLEAr appear alternately.
4. Press ENT to load frequencies or CLEAR to
cancel.
Programming Channels
If you do not have a list of frequencies in your area,
refer to www.radioreference.com.
1. Press PGM. PGM appears.
2. Enter the channel number (1–200) where you
want to store a frequency, then press PGM again.
3.Usethenumberkeysand•toenterthefrequency
(including the decimal point), then press ENT.
4. To program the next channel in sequence, press
PGM and repeat Step 3. To program a specific
channel repeat Steps 2 and 3..
• Yourscannerautomaticallyroundsdownto
the closest valid frequency. For example, if
you enter 151.473, your scanner rounds it to
151.470.
• IfError appears and the scanner beeps three
times when you press ENT, start again from
Step 2.
• Ifthefrequencyisalreadystoredinanother
channel, the scanner beeps three times and
displays - d U P L- (duplicate) and the lowest
channel number where the frequency is already
stored. Press TUNE/CLEAR to cancel. Press
ENT if you still want to store the frequency.
CONFIGURING SCANNER
To Next Page
Loading...
Need help?
General
