Whistler WS1025 User Manual

16
To turn a channel-storage bank on or off, press the
bank’snumberkey(1–0, using 0 for bank 10) during
scanning. The channel-storage banks are on when
they have a bar underneath them and off when no
bar appears underneath them.
• Youcannotturnoffallbanks;theremustbeat
least one active bank.
• Youcanmanuallyselectanychannelinabank,
even if the bank is turned off.
Setting Delay
To avoid missing a reply in conversations, a
two-second delay is automatically set for each
channel. The scanner stops for two seconds after
a transmission ends before it resumes scanning or
searching. DLY appears on the display when the delay
function is active.
To turn delay on:
•Ifthescannerisscanningandstopsonanactive
channel, quickly press •/DELAY before it resumes.
•Ifthedesiredchannelisnotselected,manually
select the channel, then press •/DELAY.
•Ifthescannerissearching,press•/DELAY. DLY
appears and the scanner adds a two-second delay
to every transmission it stops on in that bank.
To turn delay off:
Press •/DELAY while the scanner is monitoring a
channel or frequency. DLY disappears.
Using the Priority Channel
The priority feature sets the scanner to check one
specific channel every two seconds while scanning.
You can only program one frequency into the priority
channel.
1. Press PGM, then press PRI/ALERT. PCH and
000.0000 (or the previously stored frequency)
appear.
2. Enter the frequency you want stored in the priority
channel, then press ENT.
PRIORITY CHANNEL

Whistler WS1025 Specifications

General

Brand	Whistler
Model	WS1025
Category	Scanner
Language	English