12 | P a g e
Window kit Installation in a sliding door/ window
1. Open window or sliding door for approximately
5”
2. Cut the foam seal (adhesive type) to the proper
length and attach it to the bottom of the door /
window. See Fig.14.
3. Adjust the length of the window bars to the
same length and width of the opening of the
window. Cut the window piece if necessary to fit
the length of your window. See Fig. 15.
4. Close the door/ window on the window slide
bars. For long term installation, you may screw
the window kit into your window frame. See Fig.
16.
5. Cut the foam seal to the length and seal the
open gap between the top window sash and
outer window sash. See Fig.17.
To Next Page
Loading...
Need help?
General
