Wi-Tek WI-PMS310GF-Alien-I - Fast Ring Setup

WI-PMS310GF-Alien-I QSG Page 20 of 21
8.7 Fast Ring Setup
Figure 4 - Fast Ring Example
This product supports Fast Ring technology, for applications where these
requirements apply:
• High availability (uptime) is critical
• Healing (ring recovery) time less than 50 millisec.
• Between 3 & 30 switches (inclusive)
• Easy setup
To use Fast Ring:
• Use Firmware version WI-PMS310GF-Alien-I 5.1.1 (or newer).
• Use SFP ports (only) to link switches.
• Fibre, Cat5e/Cat6, or both can be used between switches.
• Enable Fast Ring mode using either of these methods:
GUI
Front
Panel
Press: 10 seconds  Ring Control = ON
Press: 20 seconds  Ring Control = OFF