Kunststoffschweißtechnik
Safety rules Chapter 2
30.06.11 Working Instructions WIDOS 5100 Page 14 of 45
2.11. Specific dangers
2.11.1 Danger of catching clothes by the planer
You can cut yourself or even get bones broken
• Only wear clothes tight to the boddy.
• Do not wear rings or jewellery during work.
• If necessary wear a hair-net.
• Always put the planer back into the reception box after and before each use.
• Transport the planer at the handle only. Do not touch the surfaces.
• Switch on the planer only for use. If the planing pressure is too high, there is the danger
that the planer tills and falls out of the machine during planing. For that reason do not press
the pipe ends stronger than necessary against the planer. If necessary, hold the planer
firmly.
2.11.2 Danger of being burnt by heating element, reception box and
welding area
You can burn yourself, inflammable materials can be ignited!
The heating element is heated up to more than 250°C!
• Do not touch the surface of the heating element.
• Do not leave the heating element unsupervised.
• Take enough safety distance to inflammable materials.
• Do wear safety gloves.
• Allways put the heating element into the heat reception box after and before use.
• Transport the heating element at the handle only.
2.11.3 Danger of Stumbling over electric / hydraulic wires
• Make sure that no person has to step over the wires.
• Lay the wires in such a way that the danger is kept to a minimum.
2.11.4 Danger of squeezing by clamping devices and guideways
There is a danger of serious injuries: On the one hand between the inner
clamping devices and on the other hand between the outer clamping device and
the end of the guideway.
• Do not stand or put hands or foot between clamped pipe ends.
• Do not stand or put hands between the inner clamping devices with not yet clamped pipes.
• Do not block opening and closing of the machine slides.
To Next Page
Loading...
