Kunststoffschweißtechnik
Starting and operating Chapter 5
30.06.11 Working Instructions WIDOS 5100 Page 20 of 45
5.2. Connection hydraulic aggregate with the basic machine
• Connect the power line plug of the hydraulic aggregate to the mains (230 V/50 Hz).
• Connect the planer to the corresponding plug of the aggregate. Connect the heating
element on an external plug box. Otherwise there is the danger of overloading the current
lead.
• Connect the hydraulic hoses of the basic machine to the quick-action couplings of the
hydraulic aggregate.
Lay the hydraulik and electro wires carefully! (Danger of Stumbling)
5.2.1 Exchanging the reduction inserts
•
Unscrew the already mounted reduction inserts by means of the Allan key being part of the
delivery.
•
Screw on the reduction inserts with the corresponding diameter.
For clamping the diameters between 200 - 315 mm, adapters are needed which have to be
screwed into the clamping shells before.
Pipes with the diameters OD 355 and OD 400 can be clamped without these adapters,
pipes with OD 450 can be clamped directly.
•
If necessary (e.g. T-pieces), the fixed outer clamping tool can be dismantled by
unscrewing the three hexagon socket screws.
Dismantling of the fixed outer clamping tool
5.2.2 Using small and large reduction inserts
Small reduction inserts:
• pipe fittings often have an only short straight surface area on which they can be clamped.
⇒ Fittings often need to be clamped in the inner clamping tools with narrow reduction inserts.
To Next Page
Loading...
