Kunststoffschweißtechnik
WIDOS Einsteinstr. 5 Phone +49 7152 9939 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Fax +49 7152 9939 - 40
info @ widos.de
http://www.widos.de
30.06.11 Working Instructions WIDOS 5100 Page 6 of 45
1. Description of product
This chapter gives important basic information about the product and its prescribed use.
All technical details of the machine are put together as a general arrangement.
1.1. Usage and purpose-oriented use
The WIDOS 5100 has been designed for heating element butt welding of pipes and fittings
with a diameter range of Ø = 200 - 450 mm.
(standard diameters: 200 / 225 / 250 / 280 / 315 / 355 / 400 / 450 mm)
It is a machine for construction sites and particulary designed for the use on-site, as well as in
the workshop.
For this reason, the frame is kept small so that it can be used even under difficult conditions
(e.g. ditch).
All use going beyond is not purpose-oriented.
The manufacturer is not responsible for damages caused by misuse.
The risk is held only by the user.
Also part of the purpose oriented use is
• respecting all the indications of the working instructions and
• performing the inspection and maintenance works.
1.2. Safety measures
In case of wrong use, wrong operation or wrong maintenance the machine itself or products
standing nearby can be damaged or destroyed.
Persons being in the endangered area may be injured.
Therefore these working instructions have to be thouroughly read and the corresponding
safety regulations must be necessarily adhered to.
1.3. Conformity
The machine corresponds in its construction to the valid recommendations of the European
Community as well as to the according European standard specifications.
The development, manufacturing and mounting of the machine were made very carefully.
To Next Page
Loading...
