WIDOS
WIDOSWIDOS
WIDOS Einsteinstr. 5 Phone +49 7152 9939 0
Wilhelm Dommer Söhne D-71254 Ditzingen Fax +49 7152 9939 40
GmbH E-mail: info@widos.de Webside: www.widos.de
16.05.17 Working Instructions WIDOS MAXIPLAST Page 18 of 41
5.
5.5.
5. Starting and operating
Starting and operatingStarting and operating
Starting and operating
The instructions of this chapter are supposed to initiate in the operation of the machine and lead
during the appropriate starting of the machine.
This includes:
• the safe operation of the machine
• using all the possible options of the machine
• economic operation of the machine
5.1.
5.1.5.1.
5.1. Starting
StartingStarting
Starting
• The machine should only be operated by initiated and authorized people.
• For the qualification a plastic welding exam can be taken according to DVS and DVGW.
• If dangers occur unplug the machine immediately.
• Switch off the machine after the work and during pauses.
• Make sure that unauthorized people are kept at a distance.
• Protect the machine from wetness and moisture!
• For working at the building site use a current distributor with a FI-security protective.
• Lay electric cables thoroughly (danger of stumbling)!
• Take care of the surrounding conditions:
The welding should not be performed under direct sun rays influence, use a welding umbrella if
necessary.
• In case of surrounding temperature under 5° C measures should be taken :
Build up a welding tent or heat up the pipe ends if necessary.
• Take measures against rain, wind and dust.
• Connect the heating element to the mains supply (230 V / 50 Hz).
5.1.1
5.1.15.1.1
5.1.1 Change of the reduction inserts
Change of the reduction insertsChange of the reduction inserts
Change of the reduction inserts
• Unscrew the in-screwed reduction inserts by means of the enlcosd Allan key.
• Screw on reduction inserts of the desired diameter.
• With respect to curves, the angle on the basic clamping tools can be set (on each side between -
15° to +15°).
To Next Page
Loading...
