MONITORING SOLUTION ENERGY
SENSeOR AMS01 User Manual 21/29
www.senseor.com
SYSTEM INSTALLATION AND CONFIGURATION
1.12 SAW TEMPERATURE SENSORS INSTALLATION
This manual does not cover all specific SAW temperature sensors installation.
For more details, see the ‘SENSeOR Installation Manual’.
1.13 SYSTEM CONFIGURATION
The reader requires a system configuration for the associated installed SAW temperature sensors, the
ambient humidity and temperature sensors and the partial discharge probe antennas.
The configuration is performed through the Ethernet network interface and uses the ‘AMS01
Configuration Tool’ application.
For configuration details, see the ‘AMS01 Configuration Tool User Manual’ for detailed instructions.
1.14 RESET AND DFU
1.14.1 DFU MODE
In case of necessity, following procedure will switch the product in DFU mode:
► Disconnect the device from power supply.
► Press and hold the Reset button.
► While holding the Reset button, connect the device to power supply.
► Hold the Reset button until LEDs are flashing with following pattern: L1 green and L2, L3 red. This
can take up to 5 seconds.
► Release the Reset button.
To Next Page
Loading...
Need help?
General
