en
28 Installation and operating instructions • Wilo-Control SC2.0-Booster • Ed.01/2023-09
7.2.1.1 Control settings -> Standby menu
Fig.18: Settings→Standby menu item
Settings for the drives, automatic release and the mode of the individual pump.
Fig.19: Settings→Standby→Drives, auto-
matic menu item
The “ON” state for drives releases the pumps so that they can be started automatically or
manually.
If the drives are set to “OFF”, no pump test run can be carried out.
The “ON” state for automatic setting enables automatic control so that pumps that are set to
automatic can be started and stopped by the controller.
If the automatic setting is set to “OFF” , and the drives are set to “ON”, the pumps can be
started manually or by the pump test run.
Fig.20: Control settings→Standby→Pump 1
mode menu item
A separate menu item is available for each existing pump.
With “OFF”, the pump is deactivated and is not included in the pump test run.
With “Manual”, the pump is started at the speed set under “Manual speed”.
7.2.1.2 Control settings -> Setpoints
menu
Fig.21: Settings→Setpoints→Setpoint 1
menu item
The setpoints are the essential setting for the operation of the unit.
The available parameters depend on the selected control mode.
The current values are displayed in the area on the right-hand side.
The values can be adjusted.
Fig.22: Settings→Setpoints→Setpoint 1
menu item
With the p-v control mode, the values pressure setpoint, share at zero-flow rate and maxi-
mum flow rate can be set.
With the p-c control mode, only the pressure setpoint can be changed.
To Next Page
Loading...