en
6 Installation and operating instructions • Wilo-Control SC2.0-Booster • Ed.01/2023-09
Knowledge regarding tools and fixation material for various
structures
• Operation/control: Operating personnel, instructed in the func-
tioning of the complete system
2.3 Electrical work
• Electrical work must be carried out by a qualified electrician.
• Before commencing work, disconnect the product from the
mains and safeguard it from being switched on again.
• Observe applicable local regulations when connecting to the
mains power supply.
• Adhere to the requirements of the local energy supply com-
pany.
• Earth the product.
• Observe technical information.
• Replace a defective connection cable immediately.
2.4 Installing/dismantling
• Wear protective equipment:
– Safety shoes
– Safety gloves for protection against cuts
– Safety helmet (when using lifting equipment)
• Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
• The procedure described in the installation and operating in-
structions for shutting down the product/unit must be strictly
observed.
• All work on the product/unit may only be carried out when it is
at a standstill.
• Disconnect the device from the mains and secure it against be-
ing switched on again without authorisation.
2.5 Maintenance tasks
• Wear protective equipment:
– Sealed safety glasses
– Safety shoes
– Safety gloves for protection against cuts
• Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
• The procedure described in the installation and operating in-
structions for shutting down the product/unit must be strictly
observed.
• Only perform the maintenance work described in these installa-
tion and operating instructions.
• Only original parts from the manufacturer may be used for
maintenance and repairs. The use of any non-original parts re-
leases the manufacturer from any liability.
• Disconnect the device from the mains and secure it against be-
ing switched on again without authorisation.
• All rotating parts must stop.
To Next Page
Loading...
General