en
Installation and operating instructions Wilo-Rexa MINI3 15
4 Transport and storage
CAUTION
Soaked packaging may tear!
The product may fall on the ground if unprotected and
may be damaged. Lift wet packaging carefully and replace
it immediately!
ƒ Wear protective equipment!
ƒ Carry the pump by the handle. Never carry or pull on the
connection cable!
ƒ Clean the pump and disinfect if necessary.
ƒ Close the discharge connection.
ƒ Protect the connection cable against kinking and damage.
ƒ Use original packaging for transport and storage.
ƒ Pack the pump when dry. Wet or humid pumps may soften
the packaging.
ƒ Storage conditions:
– Maximum: -15...+60°C (5...140°F), max. humidity:
90%, non-condensing
– Recommended: 5...25°C (41...77°F), relative humid-
ity: 40…50%
5 Installation and electrical connection
5.1 Installation types
ƒ Stationary wet well installation
ƒ Portable wet well installation
The following installation types are not permitted:
ƒ Dry well installation
ƒ Horizontal installation
5.2 Installation
ƒ Wear protective equipment!
ƒ Do not install a damaged or defective pump.
ƒ Frost-free location.
ƒ Lay the connection cable properly. During operation there
must be no danger (stumbling, damage, etc.).
ƒ Float switch must be able to move freely!
To Next Page