WILSON AUDIO Alexia - Page 44

A l e x i A O w n e r ’ s M A n u A l
44
Wilson Audio Specialties
7. Remove the Upper Array from the Woofer Module.
8. Carefully lay the Woofer Module on its side.
9. Using the caster wrench, remove the casters.
10. Insert the diode/spike assemblies into the four holes located on the bottom
of each Woofer Module. Tighten until the top surface of the Woofer Module
Diode touches the bottom surface of the “X” material plate.
11. Taking care observe the location of the woofer module to the masking tape
marking the precise location of Alexia’s position, return the module to an
upright position.
12. Re-install the Upper Array atop the Woofer Module.
figure 13—spike/diOde AsseMblY