Wilson Electronics BAIARDO L - Maintenance

BAIARDO L OPERATION MANUAL BAIARDO L OPERATION MANUAL
15 16
F5: DISPLAY RACKETS STRUNG
To go to next setting, touch UP button once. Screen will display:
This function displays the approximate number of rackets
strung. Press ENTER button to view.
* Note: Machine counts 38 strings pulled as 1 racket strung.
F6: EXIT SETTINGS
To go to next setting, touch UP button once. Screen will display:
This function exits the settings. Press ENTER button to exit.
MAINTENANCE
CLEANING THE CLAMP TEETH
• Soak an old toothbrush or shoelace in rubbing alcohol.
• Run the cleaning utensil through the clamp teeth.
• Allow to dry.
• Repeat every 1,000 pulls. Refer to Total # of pulls and divide by 38 for count.
CLEANING THE PULLER INNER SURFACE
• Soak an old toothbrush or shoelace in rubbing alcohol.
• Run the cleaning utensil through the puller inner surface.
• Allow to dry.
• Repeat every 1,000 pulls. Refer to Total # of pulls and divide by 38 for count.
CLEANING THE GLIDE RAILS
• The glide rails should be cleaned with a soft cloth dampened with alcohol.
• Run the cloth over the glide rails and inside the rail to remove and debris.
CLEANING THE DISPLAY
• Gently wipe the touch screen with a CLEAN, DRY cloth.
• DO NOT put water or other liquids on the screen.