Signal Booster Specifications
DBPro4G
Model
Number
460001
Antenna connectors
F-Femate
on
the
Inside
Antem8
l
F..femate
on
the
Outside
Antenna
Antenna impedance
7$0hm8
Dimensions
4.5
x6.44
x 1.191n.
or 11.43 x 16.3Sx
3.02
em
Weight
0.4
._
or0.18k8
Frequency
Power
output
for
a
single
phone
(uplink)
dBm
,23.7
23.8
Power
output
for
a
single
received
channel
(downlink)
dBm
Noise Figure
(typical downlink/uplink)
Power
Requirements
.
700:t-MU
Band
17
700MHJ:
Band
~3
Each
Signal
Booster is
individually
tested and factory set to ensure
FCC
compliance. The
Signal
Booster cannot be adjusted without factory
reprogramming or disabling the hardware. The
Signal
Booster
will
amplify, but not alter incoming and outgoing signals
in
order to increase
coverage of authorized frequency bands only.
If the
Signal
Booster is not
in
use for five minutes, it
will
reduce gain until a signal is detected.
If
a detected signal is too high
in
a frequency band, or if the
Signal
Booster detects
an
oscillation,
the
Signal
Booster
will automatically
turn the
power
off
on that band. For a detected
oscillation
the
Signal
Booster
will
automatically resume normal operation after a minimum
of
1 minute.
After 5 (five) such automatic restarts, any problematic bands are permanently shut
off
until the
Signal
Booster has been
manually
restarted by
momentarily removing power from the
Signal
Booster. Noise power, gain, and linearity are maintained by the
Signal
Booster's microprocessor.
Lightning
Surge
Protector
(sold separately)
Need
help?
To
Outside
Antenna
To
Signal
Booster
t
RECOMMENDED:
INSTALLING
THE
LIGHTNING
SURGE PROTECTOR
(SOLD
SEPARATELY)
INSTALL
THE
LIGHTNING SURGE PROTECTOR (LSP) CLOSE TO
THE
SIGNAL
BOOSTER.
ATIACH
THE
CABLE FROM
THE
OUTSIDE
ANTENNA TO
THE
SURGE PROTECTOR.
ENSURE THE LSP
IS
PROPERLY GROUNDED.
#859992-75
OHM MAY
BE PURCHASED
AT
WWW
W/LSONELECTRON/CS.COM
OR BY CALLING 800-204-4104.
~
www.
WilsonEiectronics.com
§\'I
D
Tech
Support
866-294-1660
Mon.-
Fri.
Hours:
7
am
to 6
pm
MST
11
To Next Page
Loading...
Need help?
General
