Wimius P63 - REMOTE CONTROL; INSTALLATION; Installation Method

support01@wimius.com support01@wimius.com
EN EN
8 9
REMOTE CONTROL
Power button
Set up
Mute
Arrow key
Return
Focus +
Focus -
Home
Menu
Mouse button
Volume +
Volume -
Source button
1. Install 2 pieces of AAA batteries into the remote before using it. Do not combine new batteries with old ones in
remote controller, which can cause operation failure due to insufcient power supply.
2. When using the remote controller, please make sure that the signal transmitter of the remote controller aims at
infrared signal receiver of the projector.
3. If you are not using the remote controller for an extended period, please take out batteries to prevent batteries
leakage.
Note:
INSTALLATION
1. Installation Method
The projector can be hanged on the ceiling with special hanger frame, and placed on the stable desk to project the
image according to the operating environment and requirements. The installation method is as follows:
Projector
Projector
Projector
Projector
Screen
Screen
Screen
Screen
1. Front Projection Ceiling mount
3. Front Projection Table mount
2. Rear projection Ceiling mount
4. Rear projection Table mount