Winco DE4040 - Table of Contents

2
OPM-171/B
TABLE OF CONTENTS
SAVE THESE INSTRUCTIONS 3
SAFETY INFORMATION 4
SAFETY DEFINITIONS
SPECIFICATIONS 5
DE4040F4 5
INTRODUCTION 6
TESTING POLICY
Rated output of generator is based on engineering tests
of typical units, and is subject to, and limited by, the
temperature, altitude, fuel, and other conditions specified
by the manufacturer of applicable engines.
PRODUCT DESCRIPTION
PREPARING THE UNIT 7
START-UP CHECK LIST
UNPACKING
LIFTING THE GENERATOR SET
INSTALLATION 8
GENERAL INFORMATION
ENGINE GENERATOR SET MOUNTING
VENTILATION REQUIREMENTS
EXHAUST INSTALLATION
FUEL INSTALLATION
INSTALLING THE FUEL LINE
INSTALLING THE AIR SYSTEM
GENERATOR ELECTRICAL CONNECTIONS
GENERATOR CIRCUIT BREAKER
GROUNDING
TRANSFER SWITCH
DC WIRING
INSTALLING THE BATTERY 13
SERVICING BATTERIES
BATTERY CHARGER
& BLOCK HEATER
STARTING PROCEDURE 15
LUBRICATION
AIR COMPRESSOR LUBRICATION
COOLANT
START CHECK LIST
DSE7310 MKII
CONTROL POWER
COMPRESSOR START UP
OPERATING CONDITIONS 18
NORMAL OPERATION
HARSH ENVIRONMENTS OPERATIONS
COLD WEATHER OPERATIONS
ADJUSTING AIR PRESSURE
AIR COMPRESSOR MAINTENANCE
CHECKING THE COMPRESSOR OIL LEVEL
CHANGING THE COMPRESSOR OIL
COMPRESSOR MAINTENANCE 19
CHANGING THE COMPRESSOR OIL FILTER
REPLACING COMPRESSOR FINE SEPARATOR CARTRIDGE
REPLACING THE COMPRESSOR AIR INTAKE FILTER
CHECKING THE COMPRESSOR PRESSURE SAFETY VALVE
ADJUSTING THE COMPRESSOR BELT
ENGINE MAINTENANCE 22
CHANGING THE OIL
CHANGING OIL FILTER
REFILLING COOLANT
CHANGING AIR FILTER
CHECKING WATER IN PRE-FILTER
CLEANING RADIATOR
REPLACING BLOW-BY FILTER
STORAGE
MAINTENANCE SCHEDULE 24
TROUBLE SHOOTING 25
ENGINE-GENERATOR SET
COMPRESSOR
ROTORCOMP
ENGINE CODES 27
WIRING SIZE TABLE 33
ENGINE HARNESS 34
ENGINE HARNESS 35
DSE7310 WIRING DIAGRAM 36
COMPRESSOR WIRING DIAGRAM 37
FAN HARNESS 38
WIRING DIAGRAMS 39
CALIFORNIA EMISSION CONTROL WAR-
RANTY STATEMENT 40
US ENVIRONMENTAL WARRANTY
STATEMENT 41
REVALIDATION OF WARRANTY 41
LIMITED WARRANTY 42