CONTROLS
86037580 GLIDE 01/03/07
3-9
7. DISPLAY TOGGLE SWITCH
The display toggle switch allows you to change the information display screen. Two screens are
available.
• INFORMATION DISPLAY –SCREEN 1
• The hour meter is viewed on screen 2 of the information display. Hours are displayed for key ON
time, brush run time, and traction motor time.
• INFORMATION DISPLAY –SCREEN 2
Records the time spent propelling the machine and gives
true traction motor time.
Records the entire time that the key is on.
Records the time spent with the brushes running and
gives true brush motor time.
Brush Run Time:
Key ON Hours:
Traction Motor Time:
• Fault codes/icon will appear on either display screen when the controller detects a problem within the electrical
system. The codes/icons are used to assist users as well as service technicians in identifying and correcting
problems. See troubleshooting section for more information on fault codes. The machine must be keyed off, then
on again, to clear fault code after repair.
• Icon appears if throttle is depressed when the key is turned on. To correct, lift foot off of throttle. If this does
not clear the icon, the throttle may be damaged and should be checked by a qualified service technician.
To Next Page
Loading...
Need help?
General