To Next PageTo Next PageWhy is there no LNB voltage on my Winegard TV Antenna?
If your Winegard TV Antenna shows no LNB voltage, it means the antenna isn't getting the 12–18 VDC it needs to power the LNBF. Check the coax connections to ensure they are properly connected. If the connections are good, further assistance may be needed.
What to do if Winegard SK-1000 TV Antenna stow failure ant not stowed?
If your Winegard TV Antenna stow failed because the antenna is not stowed, try stowing it again. If it fails again, check for obstructions that may be preventing it from stowing properly.
How to fix Winegard SK-1000 TV Antenna connection failed?
If the Winegard TV Antenna connection failed, check the data cable connection on the back of the TRAV’LER interface box to ensure it is properly connected.
Why El home failure on Winegard TV Antenna?
If you are experiencing an EL HOME failure with your Winegard TV Antenna, it means something is preventing the TRAV’LER mount from raising to find the HOME position. Look for any obstructions, especially if the unit was recently manually raised or the electronics were replaced. It may be necessary to reset the calibration.
What to do if Winegard SK-1000 not receiving 99 and 103?
If your Winegard TV Antenna is not receiving 99 and 103, make sure the B-Band Converter is installed.
What to do if Winegard SK-1000 stow failure stow unknown?
If your Winegard TV Antenna stow failed and the stow status is unknown, check the data cable connection on the back of the TRAV’LER interface. Ensure it is properly connected.
What to do if Winegard SK-1000 TV Antenna az motor stalled?
If the AZ motor on your Winegard TV Antenna is stalled, something is preventing the TRAV’LER mount from rotating. Check for any obstructions. If you find no obstructions, further assistance may be needed.
What to do if Winegard TV Antenna el motor stalled?
If the EL motor on your Winegard TV Antenna is stalled, something is preventing the TRAV’LER mount from raising or lowering. Look for any obstructions. If you find no obstructions, further assistance may be needed.
What to do if Winegard TV Antenna sk motor stalled?
If the SK motor on your Winegard TV Antenna is stalled, something is preventing the TRAV’LER reflector and LNBF from rotating. Check for obstructions. If there are no obvious obstructions, further assistance may be needed.
What to do if my Winegard SK-1000 TV Antenna connection failed?
If the Winegard TV Antenna connection fails, check the data cable connection on the back of the Trav’ler Interface to ensure it is properly connected.
General| Brand | Winegard |
|---|---|
| Model | SK-1000 |
| Category | TV Antenna |
| Language | English |
