Marine Installation Manual 2021-08 3-1
3 Engine Installation
3.1 Engine dimensions and masses
X72DF
3 Engine Installation
The purpose of this chapter is to provide information to assist in the installation
of the engine. It is for guidance only and does not supersede current instructions.
3.1 Engine dimensions and masses
Figure 3-1 Engine dimensions
Table 3-1 Engine dimensions and masses
No.
cyl.
Dimension in mm with a tolerance of approx. ±10mm
Net eng.
mass
a)
a) Without oil / water; net engine mass estimated according to nominal dimensions given in drawings, including turbocharger and SAC, piping
and platforms
A B C D E F1
b)
b) Min. height for vertical removal of piston with standard crane
F2
c)
c) Min. height for vertical removal of piston with double-jib crane
F3
d)
d) Min. height for tilted removal of piston with double-jib crane
G [tonnes]
5 8,085
4,780 1,575 10,790
Dim. depending
on TC type
13,655 13,655 12,730 2,455
481
6 9,375 561
7 10,665 642
8 11,960 716
Min. capacity of bridge crane: 7,750 kg
Min. capacity of double-jib crane
e)
: 2 x 4,175 kg
e) In cases of double-jib crane application, both hooks are used in parallel; special lifting tools are required.
When selecting the double-jib lifting method, it must be considered that maintenance work will demand additional time and effort, espe-
cially for tilted removal (F3), compared to standard procedure (F1). Availability of the special lifting tools needs to be considered in the pro-
ject schedule.
To Next Page
Loading...
