Winix ZERO 4 - Initial Operation Guide

USER MANUAL WINIX ZERO 4 AIR PURIFIER
Page 9
1. Insert the power cord into an electrical outlet.
2. Press the ‘Power’ button.
NOTE : During the rst 30 seconds of power up, the Air Quality Indicator will cycle through Blue, Amber and Red
colors. The Particle Sensors take approximately 30 seconds to gauge the air quality in the environment, after
which normal operation will begin.
3. By default, when the unit rst powers on, the mode
will be set to Auto with PlasmaWave
®
enabled.
• When in Auto mode, the fan speed will be auto-
matically adjusted according to the environments
air quality.
• PlasmaWave
®
works to remove harmful airborne
contaminants.
NOTE :
• In Auto mode, as the indoor air quality improves, the fan speed will automatically be reduced to Low.
• When the unit is running, you may hear a chirping or buzzing sound. The sound is from large particles pass-
ing through PlasmaWave
®
, it is normal and does not signify product failure. To disable PlasmaWave
®
, see
page 12.
INITIAL OPERATION