Winix ZERO Pro - Installing the Filters; Front Panel Removal; Filter Removal and Preparation


English ZERO Pro
This product comes with all of the required filters. The protective plastic wrap must be
removed from the filters before use.
※
Operating the unit without removing the plastic wrap may result in product failure.
※
Unplug and make sure the unit is turned off before installing filters.
※
The unit will automatically power off when front panel is opened.
①
Remove the front panel by grasping its
upper edge and gently pulling towards
yourself.
ˍ
To remove the front panel, the latch at
the lower edge of the panel must be
released from its position.
Latch
②
Remove the filters from the unit, they are
protected inside a plastic wrap.
③
Remove filters from protective plastic wrap.
ˍ
Operating the unit without removing
filters from plastic may cause abnormal
noise, deformation, or fire as a result of
overheating.
NOTE
ˍ
Refer to pages 15 - 18for detailed information on filter care
and how to replace them.
INSTALLING THE FILTERS