Wireless Joey Dish - Connecting and Verifying Receiver Setup

04
Installation Rules | Installing a Whole-Home System
4. Verify the connection to the receiver: At the TV connected to the desired host
Hopper receiver model, access the Whole-Home screen by pressing MENU on the
remote control and selecting Settings, Network Setup, then Whole-Home. Verify
that the Wireless Joey Access Point is detected as an attached device, as
shown below.
5. Connect the Wireless Joey receiver: At the TV where the customer wants the
Wireless Joey installed, connect the Wireless Joey receiver to the TV using an HDMI
(preferable) or RCA cable.
Warning: Do not cover the vents or stack anything on the Wireless Joey receiver.
Doing so can cause heat buildup and may damage the receiver.
6. Turn on the TV: Power on the TV and the Wireless Joey receiver. If necessary,
change the TV input to the source for the Wireless Joey receiver.