05
Installation Rules | Installing a Whole-Home System
7. Start the Setup Wizard for the Wireless Joey: When the Setup Wizard displays,
press SELECT on the front panel of the Wireless Joey to begin the connection
process to the Wireless Joey Access Point, as shown below.
8. Initiate Wi-Fi Protected Setup (WPS): Return to the Wireless Joey Access Point and
press
WPS
to connect the Wireless Joey receiver to the Wireless Joey Access Point
and the Hopper receiver model.
Note: WPS times out in two minutes. If you cannot connect the devices after several
attempts, the devices may be out of range with each other. Try moving one of the
devices closer and trying again. If there is another device that is also in WPS, stop
WPS on the device and try again.
To Next Page
Loading...
Need help?
General