Why does Wisenet Security Camera viewer get disconnected during monitoring?
Viewers might get disconnected during monitoring if there are any changes made to the camera or network configurations. To resolve this, check all network connections.
What to do if Wisenet ANO-L6012R is not detected in Device Manager?
If your Wisenet Security Camera is not being detected in the Device Manager program, try turning off the firewall settings on your PC and then searching for the camera again.
How to fix no video on Wisenet ANO-L6012R webviewer in Safari?
If no video is displayed when accessing the plug-in free webviewer on Safari via HTTPS: 1. On the authentication popup, click "View Authentication Certificate" and select the "Always trust when connecting to the designated webviewer IP" check box. 2. If the webviewer still fails, exit the Safari browser (command key + Q), access it again, and repeat the above steps.
Why Wisenet ANO-L6012R Security Camera cannot record into the Micro SD card?
If your Wisenet Security Camera cannot record into the Micro SD card, the memory card may be defective. When replacing the Micro SD card, make sure the power is disconnected from the product.
What to do if Wisenet ANO-L6012R does not operate properly with Micro SD card?
If your Wisenet Security Camera isn't operating correctly after inserting a Micro SD card, ensure the card is inserted in the proper direction. You can also format the Micro SD card again in the camera's menu under ; ; .
Why no video on Wisenet ANO-L6012R webviewer or client streaming?
If no video is displayed when you newly access the webviewer or connect streaming to the client, it might be because the maximum number of profiles available is 3. The connection may be lost if you use 4 or more profiles.
How to fix Wisenet ANO-L6012R when file is not transferred to email after motion detection?
If files are not being transferred to email after a motion detection event, verify the following settings: A. Check the settings. B. Ensure is set to . C. Confirm the option in the menu is checked.
Why Wisenet ANO-L6012R images overlap?
Images may overlap if two or more cameras are set to a single multicast address instead of different addresses. If a single address is used for multiple cameras, the images may overlap.
General| Model | ANO-L6012R |
|---|---|
| Sensor Type | 1/2.8" CMOS |
| IR Range | Up to 30m |
| Video Compression | H.265, H.264, MJPEG |
| Operating Temperature | -30°C ~ +60°C (-22°F ~ +140°F) |
| Ingress Protection | IP66 |
| Material | Metal |
| Type | Network Camera |
| Resolution | 2MP (1920x1080) |
| Focal Length | 2.8~12mm |
| Aperture | F1.4 |
| Field of View (Vertical) | 17.8°~61.2° |
| Day/Night | Yes |
| WDR | 120dB |
| Frame Rate | 30fps @ 1080p |
| Network Interface | RJ45 (10/100BASE-T) |
| Power Supply | PoE (IEEE 802.3af) |
| Lens Type | Motorized Varifocal Lens |
Detailed safety instructions for operating and installing the camera.
Step-by-step guide for installing specific camera models, including precautions.
Guide on connecting the PoE device to power and network the camera.
Manual configuration of IP address and port information for the camera.
How to receive an IP address automatically from a DHCP server.
Guide to setting up port forwarding on a broadband router for remote access.
Step-by-step instructions for manual port range forwarding configuration.
Guide to accessing the camera remotely via the internet using DDNS.
Methods for connecting to the camera via IP address or URL.
Guide on setting a secure password and logging into the camera's web interface.
How to access and configure camera settings via the web viewer setup menu.
Common problems and their solutions for camera operation and connectivity.
To Next Page
