Witschi ANALYZER Q1 - Page 33

Witschi Electronic Ltd Analyzer Q1 Page 33
TEMP.
The built-in sensor allows to measure the ambient temperature.
o
C Temperature display in Celsius degrees.
o
F Temperature display in Fahrenheit degrees.
---- No temperature display.
The ambient temperature appears in the lower result field and in the measurement log printout.
RATE
s/d Display of rate results in seconds/24 hours
s/m Display of rate results in seconds/month
GRAPHIC
ON Miscellaneous measurement results are represented graphically in addition to the
numerical display.
OFF Graphical display turned off.
MODE
Auto Automatic selection of the main measurement functions as soon as an exploitable signal
is detected.
Manual The automatic mode is turned off. All measurement functions must be selected manually.
CONTRAST
You can optimally adjust the contrast by steps from 1 to 20 according to the viewing angle or the
temperature.
LIGHT
When no measurement is running, the instrument switches to standby mode after the preset time
and the display lighting is switched off.
Preset values 15, 30, 60 min or continuous (Cont.).
BEEP – CLOCK
When this function is activated, a short beep sounds during the last five seconds of every minute.
This function can be used for setting a watch.
BEEP – TEST END
A beep sounds when this function is activated whenever a new result appears during a long
measurement time.