Measuring
mode
Information
Standard Standard measuring mode for watches with
Swiss anchor escapement.
Rate Measuring mode for the rate measurement
only of watches with cylinder, duplex or chro-
nometer escapement, in addition to watches
with unusual beat noise.
Special 1 Measuring mode for watches with Co-Axial
escapement.
Special 2 Measuring mode for watches with AP
escapement.
Special 3, 5,
7, 8 and 9
not active (reserved)
Determining the escapement type
You can find out the escapement type of the
watch that is to be tested by consulting the
watch manufacturer.
Information in the software manual
Further information on the measuring modes is
to be found in the corresponding software
manual.
The “Chronoscope Service” display software provides two dif-
ferent display modes for the ChronoMaster and ChronoMaster
PRO versions:
• Continuous diagram recording
• Vario
The following display modes are also available for the Chrono-
Master PRO version:
• Trace
• Sequence
• Polar
• Scope 1, Scope 2
Information in the software manual
Further information on the display modes is to
be found in the corresponding software
manual.
Display modes
01.09.2020 Precision measuring device ChronoMaster 9
To Next Page
Loading...
