Technical data
4 FB 7100 PLUS 10.2011
TECHNICAL DATA
The technical data of the vending machine are given on the rating plate.
The vending machine is suitable for indoor use only.
Dimensions vending ma-
chine
Height: min. 850 mm (without levelling feet), max. 875 mm (with levelling feet)
Width: 450 mm
Depth: 378 mm (cabinet), 475 mm (cabinet+door)
Weight 64 kg (without ingredients)
Electric connection Power supply: 230V, 50 HZ
Lines: Single line+neutral+earth (IEC-standard)
Brown = line
Blue = neutral
Yellow/green = earth
The vending machine must be earthed! In addition, it is recommended to
install a fault current safety switch.
Power consumption: 2000 - 2450W
Connecting cable: Approx. 1.8-3.5 m (varies, depending on local requirements).
Fuse: Transformer, primary: 2A
Transformer, secondary (on VMC): 8A
Water connection Water system connection: The vending machine must be connected with the potable water system according
to the provisions in force in the place of installation of the equipment.
Min. back pressure without chiller: 0.8 bar (0.08 MPa)with chiller: 1.5 bar (0.15 MPa)
Max. pressure: without chiller: 10 bar (1.0 MPa)with chiller: 8 bar (0.8 MPa).
Hose connection: Connect the water network with the 3/4” gas union of the water inlet solenoid valve
by means of a tube that can support the network pressure and of a type suitable for
foodstuffs (min. inner diameter 6 mm.).
It is recommended to apply a water tap on the water network outside the machine in
an accessible position.
To Next Page
Loading...