102
User Manual WMF1500 S +
Messages and instructions
Error pattern Action instructions
• Milk foam not OK
• Temperature too cold or
too hot
Basic Milk
Change milk nozzle
Use asuitable milk nozzle on the combi spout.
Milk nozzle 3kW
• very cold milk (up to 8°C) green
• chilled milk (8to 16°C) white
• non-chilled milk (above 16°C) caramel
Clean the combi spout
w Care w Clean milk system manually, page 88
If error not remedied
Use another milk nozzle from the accessories
• Milk foam not OK
• Temperature too cold or
too hot
EasyMilk/DynamicMilk
Check whether the milk temperature is the same
as the set temperature
DynamicMilk
Perform aquality check
• The milk foam
dispensing sputters
severely
• Milk too hot
Check whether the milk system has been cleaned
Clean the milk system
w Care w Milk system cleaning overview, page 77
Check whether the milk has been cooled
sufficiently
• No powder beverage
dispensing
Clean the mixer bowl
Is the hose kinked?
Perform milk cleaning and rinsing more often, if
necessary daily
w Care w Milk system cleaning overview, page 77
Use lower powder dosage
Use higher water dosage
• Pump runs
continuously, water in
grounds container
Switch the coffee machine off and on again
If error not remedied call WMFService