87
Note:
We recommend switching off the machine when
changing the labels, to prevent a beverage key being
pressed in error.
Otherwise, there is a danger of burning and
scalding.
You can label the beverage keys 13 as you choose. To do
this, press on either the left-hand or right-hand side of the
key strip and, while still pressing, slide the key strip out
sideways until the key strip comes out of its holder.
Remove the key strip from its holder.
You can now replace the existing labels with labels which
you have made yourself. You can print your own labels on
plastic, cut to size and insert in place.
After changing the plastic labels, replace the key strip. To
do this, insert the key strip into the holder, pressing evenly
on both sides of the key strip until it clicks into position
into the holder.
7.4 Adjusting the height of the front panel (optional)
Note:
Front panel height adjustment is only available
as an option.
When you dispense a cup, pot or mug of coffee, the front
panel 12 remains fully down all the way to the stop. The
key lights in the Cup, Pot and Mug beverage keys are lit,
and the key light for Jugs is extinguished.
To fill jugs and containers over 140 mm high, the complete
front panel 12 has to be pushed fully up all the way to the
top. The key lights in the Jug and Hot water 10 beverage
keys are lit, and the key lights for Cup, Pot and Mug are
extinguished.
13
12
6
10
To Next Page
Loading...
Need help?
General
