EasyManua.ls Logo

Wolf-Guard YL007-M2C - Page 16

Wolf-Guard YL007-M2C
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Note:
the last three functions could be realized only when the GSM
signal intensity reaches 20.
[Care and Maintenance]
The alarm system has excellent design and uses advanced
technologies. It shall be used with care. The following suggestions are
required to maintain your obligations under the warranty terms, and for
prolonging the service life of the system.
Place the control panel and all parts and accessories out of
children's reach.
Keep the alarm system dry. Rain, humidity and various fluids or
moisture all will corrupt the electronic circuit.
Do not use or place the alarm system in dirty locations, otherwise
the electronic elements will be damaged.
Do no place the system in excessively hot locations. High
temperature will shorten the service life of electronic equipment,
damage batteries, deform or even melt some plastic parts.
Do not place the system in excessively cold locations. Otherwise
condensation many occur and damage the circuit board of the
alarm system.
It is recommended that you check and test the alarm system
periodically:
Check the main unit every three months:
1.Whether it can arm/disarm normally;
2.Whether it can dial the number for alarm normally;
3.Whether it can receive wireless detectors’ signal normally;
4.Whether the back-up battery can work normally.
Care and Maintenance
28
27
Care and Maintenance
Check the wireless detectors once a month:
1.Trigger wireless detectors to see if system can alarm normally;
2.Check all detectors’ batteries to see if it’s in low voltage;
3.Check whether wireless detectors can send signal to the main unit
normally.
Check the SIM card:
1.Check the use of SIM card, such as network signal, balance, etc.
2.Make sure the PIN code verification of the SIM card is closed.
3.Please keep the password and SIM card number safe, in case that
other people remote control the system illegally.
Since the alarm system is continuously in operation or standby mode,
the supply adaptor of the control panel shall be connected to a safe
and reliable socket.
Do not place the system near your bedroom or office table, because
the siren will make high-loudness sound in the case of alarm, which
may adversely affect your rest or work.
If the alarm system will not be used for a long time, please
disconnect the system from the power supply.
Please do not disassemble, repair or alter the products without
permission, or it may cause accidents and faults.
Do not drop this product on the ground or on hard objects, as it may
lead to massive impact to cause faults and damages.
Without approval and consent of relevant authorities, please do not
set “110”, “119” or the alarm phone number of police station for this
main unit.
Please read the suggestions above carefully and follow the
instructions herein. If any of the equipment does not work properly,
please send it to the dealer or authorized service point for repair.
We will try our best to solve the problem for you as soon as
possible.
[Dial telephone
number] +[ ]
System Dialing
Function
[95175308246]
+ [#]
Factory Reset
Use with caution
[operation
password] + [1]
Arm by SMS
[operation
password] + [2]
Disarm by SMS
Default operation password: 1234
[operation
password] + [3]
Alarm Record
Checking by SMS
Default operation password: 1234
Default operation password: 1234