Wolf BM-Solar - Display Values - Descriptions (A:01-A:06); Display Value Descriptions A:01-A:06

10 3061916_0611
SM1: Thecurrenttemperatureofthesolarcylinderatthelevelof
thesolarindirectcoilisdisplayed.
SM2: Thecurrenttemperatureofsolarcylinder1atthelevelof
thesolarindirectcoilisdisplayed.
A : 0 1
SM1: Actual
 DHWtemperature
Solarcylinder
SM2: DHW
Actualtemperature
 Solarcylinder1
SM1: ThemaximumDHWtemperatureoverthecourseof24hours
isdisplayed.
SM2: The maximum DHW temperature of cylinder 1 over the
courseof24hoursisdisplayed.
 Thisvalueisresetevery24hours.
A : 0 2
SM1: Maximum
DHWtemperature
Solarcylinder
SM2: Maximum
DHWtemperature
Solarcylinder1
SM1: Thecurrenttemperaturecapturedattheoutlet(ow)ofthe
collectororcollectorarrayisdisplayed.
SM2: Thecurrenttemperaturecapturedattheoutlet(ow)ofthe
collectororcollectorarray1isdisplayed.
A : 0 3
SM1: Collectortemperature
SM2: Collectortemperature,
collectorarray1
SM1: The maximum collector temperature over the course of
24hoursisdisplayed.
SM2: The maximum collector temperature of collector array 1
overthecourseof24hoursisdisplayed.
 Thisvalueisresetevery24hours.
A : 0 4
SM1: Maximumcollector
temperature
SM2: Maximumcollector
temperature
Collectorarray1
SM1: Thecurrenttemperatureofthesolarcircuitreturnisdisplayed.
Thisvalueisrequiredforcalculatingtheyield.
SM2: The current value captured by the sensor connected
to input E1 is displayed. Subject to the conguration
set at the SM2, this may be the return temperature, the
actual DHW temperature of solar cylinder 2, the actual
DHW temperature of solar cylinder 3 or the heating
temperature.
 Thisvaluewillonlybedisplayedifatemperaturesensor
hasbeenconnected.
A : 0 5
SM1: Returntemperature
SM2: InputE1
SM1/ Thecurrentowrateinl/min(litresperminuteisdisplayed.
SM2: This display is only shown if value 1 or 2 has been
selectedforparameter08(capturingtheamountofheat).
 Thisvalueisrequiredforcalculatingtheyield.
A : 0 6
Solarcircuitowrate
Description of the display values
Display level