Wolf CWL-2-325 - Display; General explanation of control panel

6 Display
6.1 General explanation of control panel
A display with touchscreen is located at the front of the appliance. This display is used to operate the
appliance and to provide the user with information about the status of the appliance. When the mains
power is switched on, the software version is first shown; the main screen is then displayed.
Main screen
1 = Current time
2 = Info connections (only displayed if applicable)
3 = Current date
4 = Set ventilation flow rate; the red bars indicate the selected ventilation flow rate.
In this example the active ventilation flow rate is 100 m
3
/h
5 = Active control
6 = Filter message (only displayed if applicable)*
7 = Fault (only displayed if applicable)*
8 = Access to settings menu
9 = Access to information menu
*
Filter message and fault message are located in the same place on the display; fault display has a higher
priority, and so will always be shown first even when there is an active filter message!
The factory setting of the menu is English.
The desired language/ date & time can be modified in the settings menu ;for this, please refer to the
settings value table (® Setting values page 46) step number 15.1 to step number 15.10.
Display
18 | WOLF GmbH 7100832_202010