OPERATION
Edger Setup
Operation EGdoc091010 3-4
3
5. Emergency Stop
Push the emergency stop button to stop the blade and the track feed motors. Turn the emergency
stop clockwise to release the stop. The machine will not restart until the emergency stop is released.
3.3 Edger Setup
IMPORTANT! Before starting to use the Edger you have to meet the
following conditions:
Set up the machine on firm and level ground
The machine should be operated with the sawdust collection system
The machine can be operated under roof only
The machine can be operated in temperature range from -15
o
C to 40
o
C only
Light intensity at operators position must be 300lx
The machine operator’s position is shown below
Have a qualified electrician install the power supply (according to EN 60204 Standard). The
power supply must meet the specifications given in the table below.
FIG. 3-1
3-Phase Volts Fuse
Disconnect
Suggested Wire Size
400 VAC 40 Amps
4 mm
2
, up to 15 m long
TABLE 3-1
!
Tb0042
To Next Page
Loading...
