OPERATION
Control Overview
3
3-3 EGdoc091010 Operation
3.2 Control Overview
1. Control Panel
See Figure 3-1. The control panel includes: START-STOP switch, blade distance automatic
controller, feed rate knob, automatic controller ON/OFF switch, additional switches for setting blades
distance and emergency stop button.
2. Blade Drive
To start the blade motor press the START button. To stop the blade motor, press the STOP button.
3. Feed Roller Speed Adjustment
The feed roller speed switch controls the speed at which the feed roller moves. Turn the switch right
to increase the speed, turn left to reduce the speed.
4. Edger Setworks Controller
Allows to set blade position automatically. See Section SECTION 3 SETWORK OPERATION
(Optional Equipment)
FIG. 3-1 CONTROL PANEL COMPONENTS
START
STOP
Tb0039B
TBS 01 Setworks
Real Size (mm)
Check real size
AUTO
CAL.
SAVE
SET
BCDE
Position Size (mm)
ENTER
A
B
C
D
E
SET
REAL SIZE
To Next Page
Loading...
