OPERATION
Machine Start
Operation EGdoc091010 3-6
3
3.4 Machine Start
DANGER! Before starting the machine, perform these steps to avoid
injury and/or damage to the equipment:
Close the blade housing covers and replace any guards removed for service.
Check the feed rollers and remove all loose objects such as tools, wood, etc.
Make sure all persons are a safe distance from the machine.
Check that the emergency stops are released.
NOTE: The machine will not start if either of the emergency stops is
on.
Before starting the blades, check that the main power switch servicing the machine is on.
See Figure 3-2. Start the blade motors. To do this, turn the switch to the “1” position and then push
the START button on the control panel (see the figure below). The motor should start and the feed
rollers should start.
To stop the blade motor, push the Stop button shown in the figure above. The motor also may be
stopped by pushing the emergency stop button.
FIG. 3-2
START
STOP
TBS 01 Setworks
Real Size (mm)
Check real size
AUTO
CAL.
SAVE
SET
ABCDE
Position Size (mm)
ENTER
A
B
C
D
E
SET
REAL SIZE
To Next Page
Loading...
