Wood-mizer Edger Multi-Rip - Operation, Memory Buttons (A, B, C, D, E)

SETWORKS OPERATION
Operation, Memory Buttons (A, B, C, D, E)
SETWORKS OPERATION EGdoc090110 4-5
4
on the scale. If not, See Section 5.7 for alignment instructions.
 Enter the distance between the blades without any pauses. Confirm by pressing .
4.3 Operation, Memory Buttons (A, B, C, D, E)
After switching-on, the TBS-01 inscription appears on the display, and the setworks is ready for
operation within a few seconds or after is pressed.
 To set the blades to any width, enter the blades width value using keypad and press .
The blades will automatically move to the entered width value.
 You can also change the blades width manually using .
You can store up to 5 blades width values using the memory buttons.
 To store the width value using the memory button, press and hold . On the upper display the
“ABC” will appear. Press the memory button (A, B, C, D or E), enter the width value and confirm by
pressing . Perform the same procedure for other memory buttons. Press to exit this
function.
ENTER
ENTER
ENTER
SET
ABCDE
SAVE
SET
ABCDE