Wood-mizer Edger Multi-Rip - Page 36

SETWORKS OPERATION
Operation, Memory Buttons (A, B, C, D, E)
4
4-6 EGdoc090110 SETWORKS OPERATION
See Pic. 4-4.
 To use the stored value, press the required memory button and confirm by pressing . The
blades will move to the stored width.
NOTE: If during normal operation the “Check real size” lamp start blinking,
press and hold the button. Measure and enter the distance
between the blades with an accuracy of 0,1 mm. For example: if you want
to enter 102mm - press 1-0-2-0 without any pauses and confirm by
pressing .
PIC. 4-4
TBS 01 Setworks
Real Size (mm)
Check real size
AUTO
CAL.
SAVE
SET
ABCDE
Position Size (mm)
ENTER
A
B
C
D
E
SET
REAL SIZE
ENTER
SET
REAL SIZE
SAVE