2 EGdoc091010Table of Contents
Table of Contents Section-Page
SECTION 1 SERVICING THE EDGER 1-1
1.1 If You Need To Order Parts ...................................................................1-1
1.2 Customer and Edger Identification.........................................................1-1
1.3 If You Need Service...............................................................................1-2
1.4 Edger Components .................................................................................1-2
SECTION 2 SAFETY 2-1
2.1 Safety Symbols.......................................................................................2-1
2.2 Safety Instructions..................................................................................2-1
SECTION 3 OPERATION 3-1
3.1 Pre-Operation Check ..............................................................................3-1
3.2 Control Overview...................................................................................3-3
3.3 Edger Setup ............................................................................................3-4
3.4 Machine Start..........................................................................................3-6
3.5 Blade Installation....................................................................................3-8
3.6 Edging Lumber.....................................................................................3-13
SECTION 4 SETWORKS OPERATION 4-1
4.1 Edger Controller Panel...........................................................................4-1
4.2 Start-up settings of the controller...........................................................4-2
4.3 Operation, Memory Buttons (A, B, C, D, E)..........................................4-5
SECTION 5 MAINTENANCE & ALIGNMENT 5-1
5.1 Changing the Blades...............................................................................5-1
5.2 Tensioning the Belts...............................................................................5-3
5.3 Tensioning the Chains............................................................................5-4
5.4 Checking the Rollers ..............................................................................5-6
5.5 Lubrication .............................................................................................5-6
5.6 Maintaining and Sharpening Anti-Kickback Fingers.............................5-7
5.7 Alignment...............................................................................................5-7
5.8 Blade Sharpening..................................................................................5-10
5.9 Using the Blades...................................................................................5-11
SECTION 6 SPECIFICATIONS 6-1
6.1 Overall Dimensions................................................................................6-1
6.2 Multirip Edger Specifications.................................................................6-2
6.3 Electrical Diagram..................................................................................6-4
6.4 Electrical Component List......................................................................6-6
6.5 Dust Extractor Specifications.................................................................6-7
To Next Page
Loading...
