Wood-mizer Edger Multi-Rip - Start-Up Settings of the Controller

SETWORKS OPERATION
Start-up settings of the controller
4
4-2 EGdoc090110 SETWORKS OPERATION
Descriptions of the control panel buttons:
A, B, C, D, E - blades width memory buttons.
SET ABCDE - Sets the blades width value to each memory button.
Save - Saves parameters determined by operator.
Blades width manual setting buttons (in/out).
ENTER – enters the value to the memory
Auto Mode – Adjustment of the setworks automatic calibration parameters. Used for initial calibration
and re-calibration if dimensional error occur.
Set Real Size - Sets the real distance between saw heads. Should be set when “Check real size”
indicator lamp blinks.
4.2 Start-up settings of the controller
1. Setting the input divider (entered only once, at the first start-up)
 Switch on the controller by turning the main switch to ON position.
 When the text “TBS-01” appears on the display, press and hold until the divider value
appears on the lower right display.
 Enter the correct value of the divider (for Edger the divider value should be 5).
A
SET
ABCDE
SAVE
ENTER
AUTO
CAL.
SET
REAL SIZE
AUTO
CAL.