Wood-mizer Edger Multi-Rip - Page 33

SETWORKS OPERATION
Start-up settings of the controller
SETWORKS OPERATION EGdoc090110 4-3
4
See Pic. 4-2.
 Press to save the entered divider value.
1. Auto-calibration
This function should be used in case of: replacement of any component of the blades width setting
system, motor or after lubrication of the chains and other moving elements or when significant cutting
variances are observed;
 Switch on the edger by turning the main switch to ON position. and wait until the text “TBS-01”
disappears.
 Using buttons set the blades to 180 mm width.
 Press and hold down . After a while - the text “Aut” will appear on the displays. The
controller is ready for auto-calibration.
PIC. 4-2
TBS 01 Setworks
Real Size (mm)
Check real size
AUTO
CAL.
SAVE
SET
ABCDE
Position Size (mm)
ENTER
A
B
C
D
E
SET
REAL SIZE
SAVE
AUTO
CAL.