Wood-mizer Edger Multi-Rip - Page 34

SETWORKS OPERATION
Start-up settings of the controller
4
4-4 EGdoc090110 SETWORKS OPERATION
See Pic. 4-3.
 Press again, the controller successively performs some movements of the blades.
After performing the last movement, measure and enter the real head width using the keypad.
Confirm by pressing .
2. Real blades width entering.
To ensure, that upper display shows the correct blade width, it is necessary to enter real blades width.
It must be done on the first start-up and also when:
- significant cutting variances are observed;
- a sudden power disappearance happend when the controller was setting the blade width;
- any repairs to blades drive system was made.
To enter the real blade width:
 Press and hold
 Using the the scale, set the blades to full measurement (for ex. 250mm)
 Measure the distance between the blades and make sure if the measured distance is the same as
PIC. 4-3
TBS 01 Setworks
Real Size (mm)
Check real size
AUTO
CAL.
SAVE
SET
ABCDE
Position Size (mm)
ENTER
A
B
C
D
E
SET
REAL SIZE
AUTO
CAL.
ENTER
SET
REAL SIZE