OPERATION
Machine Start
3
3-7 EGdoc091010 Operation
See Figure 3-3. The speed at the feed rollers move is adjustable by dial lockated on the control
panel, allows the operator to adjust the feed rate from 0 to ca. 25 m per minute.
Turn the switch clockwise to increase the feed rate, counterclockwise to slow the feed rate down.
Factors that will determine what feed rate you can use include:
Log diameter.
Hardness of material to be cut. Some woods that are seasoned or naturally very hard will
require slower feed rates.
Sharpness of blades. Dull or improperly sharpened blades will require slower feed rates than
sharp and properly maintained blades.
Off-bearing capability. Your ability to feed will also determine what feed rate you can use.
FIG. 3-3
START
STOP
Tb0039B
TBS 01 Setworks
Real Size (mm)
Check real size
AUTO
CAL.
SAVE
SET
ABCDE
Position Size (mm)
ENTER
A
B
C
D
E
SET
REAL SIZE
To Next Page
Loading...
