OPERATION
Edging Lumber
Operation EGdoc091010 3-14
3
See Figure 3-4. The board guide fence allows guide the board parallel. Release the locking bolt to
adjust the board guide fence.
4. Move the blades as desired. If using a fence as a guide, use the corresponding scale to determine
the width of the board after edging. The laser will show the path of the blade to help you decide how
wide to cut. If edging both sides of the board, use the scale at the top of the edger and or setworks
display to determine the width of cut. Again, the lasers show the path of the blades. For instructions
how to use Setwork, See Section 4.1 Edger Controller Panel
5. Start the blade motor and the feed motor. Set the board feed speed as desired. Push the board into
the edger until the feed system takes the board.
IMPORTANT! If at any time you need to immediately stop the motor
and/or Edger operation, press the Emergency Stop button located at
FIG. 3-4
Tb0068
Board
Guide
Fence
Locking
Bolt
Laser
Guides
!
To Next Page
Loading...
