Maintenance & Alignment
Alignment
5
5-8 EGdoc091010 Maintenance & Alignment
and slide the laser as necessary. Next, tighten the mounting bolts.
See Figure 5-5.
Adjustable blade and its laser indicator alignment
6. To position the adjustable blade, set the blade to 200mm using buttons and scale. Measure
from the inside of the fixed blade to the inside of the movable blade. If necessary, loosen the movable
blade arm and slide the blade assembly on the shaft until the blades are 200mm apart. Retighten the
blade arm. If the adjustable blade has been aligned, it is necessary to perform the auto-calibration
procedure and enter the real blade width to Setwork Controller (See Section 4.2
).
Correct the scale indicator position if necessary.
FIG 5-5
60mm
Laser
Laser Beam
To Next Page
Loading...
