Alignment
Blade Height Scale Adjustment
Alignment 15doc092413 6-15
6
6.12 Blade Height Scale Adjustment
After the entire sawmill has been aligned and all adjustments made, check that the blade height
scale indicates the true distance from the blade to the bed rails.
1. Move the saw head so the blade is positioned directly above one of the bed rails. Measure from the
bottom edge on a down-set tooth of the blade to the top of the bed rail (or stainless steel sleeve if
applicable).
See Figure 6-16.
2. Loosen the indicator bracket mounting bolt and nuts, adjust the bracket until the indicator is aligned
with the correct mark on the scale. Retighten the bracket mounting bolt and nuts.
For example, if the measurement from blade to bed rail was 14 3/4" (375 mm), make sure the
indicator reads 14 3/4" (375 mm) on the scale.
FIG. 6-16
Loosen indicator
bracket mounting
bolt
Loosen indicator
bracket mounting
nuts
To Next Page
Loading...
