Wood-mizer LT15 - Feed Rope Assembly

SAWMILL ASSEMBLY
Feed Rope Assembly
SAWMILL ASSEMBLY 15doc092413 2-16
2
2.6 Feed Rope Assembly
1. Install a feed rope mounting bracket at each end of the bed assembly using a M10x30 hex head
bolts and washers. Either bracket should be angled toward the end of the frame at which it is
mounted as shown below.
See Figure 2-13.
2. Tie a knot in one end of the feed rope. Slip the knotted end of the rope into the front rope mount
bracket. Route the rope between the saw head and main bed frame tube.
See Figure 2-14.
FIG. 2-13
FIG. 2-14
150110F
M10x30 Bolt
Front Rope
Mount Bracket
502725-1
10.5 Flat
Washer
Rear Rope
Mount Bracket
502726-1
M10x30
Bolt
10.2 Split Washer
10.2 Split
Washer
10.5 Flat
Washer
15B007d