Wood-mizer LT35 - Electrical Problems

Troubleshooting Guide
Electrical Problems
Troubleshooting Guide WMdoc072619 6-2
6
6.2 Electrical Problems
WARNING! Before performing service near moving parts such as
blades, pulleys, motors, belts and chains, first turn the key switch to
the OFF (#0) position and remove the key. If the key is turned on and
moving parts activated, serious injury may result.
WARNING! Disconnect and lockout power before performing any ser-
vice to the electrical system. For battery-powered equipment, discon-
nect the negative battery terminal cable.For AC-powered equipment,
follow the lockout procedure provided in the safety section (See Sec-
tion 2.3). Failure to do so may result in injury and/or electrical system
damage.
Height Adjustment Jumps or
Stutters When Moving Up or
Down.
Up/down chain improperly
adjusted.
Adjust up/down chain.
Lumber Is Not Square Vertical side supports not
square to bed
Adjust side supports.
Blade not parallel to bed rails Adjust bed rails parallel to blade.
Sawdust or bark between cant
and bed rails
Remove particles
Tooth set problems Resharpen and reset blade
Sawdust Builds Up On Track Excessive oiling Do not oil track
Track wipers worn Adjust wipers to firmly contact track
Track is sticky Clean track with solvent and apply
silicone spray
Wavy Cuts Excessive feed Slow feed rate
Improperly sharpened blade
(This will be the problem 99%
of the time!)
Resharpen blade (See Sharpener
Manual - read entire manual!)
Blade guides improperly
adjusted
Adjust blade guides.
Sap buildup on blade Use Water Lube.
Tooth set problem Resharpen and reset blade
PROBLEM CAUSE SOLUTION
Up/down Excessively Slow. Up/down belt loose. Adjust belt to be as loose as possible
without slipping.
Vertical wear pads too tight. Adjust pads.
PROBLEM CAUSE SOLUTION